uxcell Motor Fan Blade 116mmx14mm Round Shape Bore Black Engineering Plastic with 12 Vanes

Worked perfectly

Put this on an old Delta AP400 dust collector motor that was seized, after I bent the original fan off the arbor to repair the motor. This fits great, has a little flex, and pushes a lot of air over the motor case.

It was so easy to replace the old fan with this part. A snap!!!

I used this to a replace a broken fan on an old motor. The dimensions were correct, the material is appropriate and the molding was pretty good. I did clean up some mold flash and machine down the provided spacer to get the clearance I needed, but these were minor things and particular to my installation.

Worthless….couldn’t get it tight enough…did not blow air…removed it and put it in the trash can.

I made the mistake of buying an air compressor from harbor freight. 4 months in the engine seized up. Took it apart and the fan blade melted in the center and then froze up sideways. I would say it wasnt tighten during assembly at factory. Anyways, I pried it off and put this blade on. Been going well a couple of months now.

Modified this to replace jump house fan... worked like a charm.. good hard plastic durable

I installed it on pool pump on the exterior “tail fan”Fit good on the shaft . But with Normal high RPMThe circular shape lost its round shape .Cheap materials plastic is not heavy duty PVCOver priced for the quality